The difference between mipi dsi and csi has found only three main places for the time being
1: dsi csi short packet line sync header, field sync header will be different
dsi line field sync header

csi

2: End package eotp
dsi

csi

3: The packetization method is different
dsi event mode

csi

Reference materials:csi reference
Table of contents 1. MIPI concept 2.CSI、DSI、UFS 3.C-PHY、D-PHY、M-PHY 4. Detailed explanation of C-PHY, D-PHY, M-PHY 4.1 C-PHY 4.2 D-PHY 4.3 M-PHY 5. Summary of C-PHY, D-PHY, M-PHY 1. MIPI concept ...
The first step in opening the chart journey is to connect the MIPI display to the RK3399 development board, like this: The two are actually connected through the cable, so what is the software world? ...
In the past two days, a new project was screened, and an adapter cable was added to the old machine to debug in advance. I haven't adjusted the screen for a long time. I used to remember a 1,2. There ...
Original address: http://blog.csdn.net/qq160816/article/details/19555957 1. MIPI MIPI(Mobile industry processor interface)YesMobile Industry Processor Interfaceabbreviation of. MIPI (Mobile Industry P...
1. Types of MIPI: Mipi includes: dsi (display serial interface) csi (camera serial interface) dsi and csi share a physical layer protocol D-PHY. DSI protocol also involves some other top-level protoco...
1. Introduction to DSI The latest protocol supports up to 4.5Gbps/lane 1.1DSI working mode DSI has two working modes: command mode and video mode Command mode: The host indirectly controls the display...
Clock -related term Porch: In the LCD timing, some parameters often use Hsync, HBP, HACTIVE, HFP, vsync, VBP, VAVTIVE, VFP, the concept is as follows: H-total = HSYNC+HBP+HACTIVE+HFP V-total = VSYNC+V...
Table of contents 1. Mode 1.1, Command mode 1.2, Video mode 2. Physical connection and PHY 3. Level division 3.1, physical layer characteristics 3.1.1, data transmission 3.1.2, two -way transmission d...
Date: 2015.01.14 1. Opening instructions I have been debugging LCD screens under the MTK platform these days, and they are all connected using the MIPI interface. When I modified their drivers, I noti...
Transmission mode LP (Low-Power) mode: used to transmit control signals with a maximum rate of 10 MHz HS (High-Speed) mode: used for high-speed data transmission, speed range [80 Mbps, 1Gbps] per Lane...