Call up matlab homepage during Carsim/Simulink co-simulation

tags: Carsim/Simulink matlab Experience sharing

When Carsim and simulink are co-simulating, after clicking send to simulink, only the MATLAB command window appears, as shown in the figure below.

But it is more convenient for us to process some data on the main page of MATLAB in many cases. At this time, we can enter in the command window

desktop

Press Enter to open the MATLAB homepage, as shown in the figure below.

Intelligent Recommendation

Autonomous Driving Simulation (5) - Co-simulation based on Carsim, Prescan, Simulink

Autonomous Driving Simulation V - Co-simulation based on Carsim, Prescan, and Simulink 1. Co-simulation process 2. CarSim co-simulation configuration points 3. Prescan co-simulation configuration poin...

prescan + carsim + simulink co-simulation vehicle model distorted

Question: prescan + carsim + simulink co-simulation model the deformation of the vehicle,As shown below Analysis **: ** overlaps with the tire of the vehicle body, the vehicle model is set in CarSim e...

Carsim/Simulink co-simulation Wrong version of Vehicle Solver DLL

Carsim/Simulink co-simulation always prompts an error, Wrong version of Vehicle Solver DLL,As shown below. Solution: 1. After opening the light blue link box under Send to Simulink, select the number ...

Prescan+CarSim+simulink co-simulation vehicle model deformation

prescan+carsim+simulink joint simulation vehicle model deformation Prescan+CarSim+simulink joint simulation, abnormal vehicle attitude online solution Modify Prescan parameters CarSim parameter modifi...

Solving the problem of mismatching input and output in the process of Carsim and simulink co-simulation

questionYes: Before I add the UKF module, I can co-simulate normally; after adding the UKF module, there will always be an error, which probably meansThe number of variables in the output part of cars...